Please wait

Your message is being sent

An error occurred

Glass Oven B-585 Drying | Type: B-585 Drying
Glass Oven B-585 Drying | Type: B-585 Drying
Brand: Büchi Labortechnik GmbHFor gentle drying of small and medium sized samples and removal of residual solvents in the temperature range up to 300 °C. The process can be accelerated by optionally applying vacuum. An adjustable angle of up to 90° allows larger sample volumes.High yield by gentle sample treatmentEasy operation with multiple pre-settingsFull control due to optimal visibility of the samplesCompact design
€4.440,00
Grid shelves for incubators BD-S and drying and heating chambers ED-S / FD-S
Grid shelves for incubators BD-S and drying and heating chambers ED-S / FD-S
Brand: BINDER GmbHAvailable in 2 variantsGrid shelf incl. shelf support.
€35,70
Heating bath HB 1500 / HB 1500-S | Type: HB 1500, Capacity of the bath litres: 2, Min. operating temperature RT + °C: 20
Heating bath HB 1500 / HB 1500-S | Type: HB 1500, Capacity of the bath litres: 2, Min. operating temperature RT + °C: 20
Brand: Juchheim GmbH & Co.KGAvailable in 6 variantsThe heating bath HB 1500 is developed for varied tasks. As bath filling water, oils and sand is used. Different sizes are deliverable! The device has an integrated temperature controller with microprocessor. It is freely programmable and has also self optimization function and rampfunction!Microprocessor controller with 4-digits 7-segment display, 10 mm high, green,With selfoptimization and rampfunctionMeasurement and control range +20,0 to +250,0°COn-Off switch is light up greenSetting of heat power from 1 to 99%Irreversible rapid shut-down when reaching the security temperatureHeating bath HB 1500-SEquipment such as HB 1500, also with safety on separate microprocessor controller and an internal temperature sensor. Exceeding the safety temperature, the heating is switched off completely. The over-temperature shutdown >10K + reference deleted.
€1.150,00
Heating bath HB 1500-S | Type: HB 1500-S, Nominal capacity: 8 l, Temperature: 20 ... 260 °C
Heating bath HB 1500-S | Type: HB 1500-S, Nominal capacity: 8 l, Temperature: 20 ... 260 °C
Brand: Juchheim GmbH & Co.KGAvailable in 3 variantsThe heating bath HB 1500-S is developed for varied tasks. The bath can be filled with water, oil or sand. The appliance is equipped with 2 temperature controllers with microprocessor. The upper temperature controller serves as a safety temperature limiter. If the safety temperature is exceeded, the heating is switched off at all poles. The temperature is measured via an internal temperature sensor at the bottom of the pot.Microprocessor controller with 4-digit 7-segment display, 10 mm high, greenFreely configurableSelf-optimising temperature controlMeasuring and control range up to 260 °CSetting of heating power from 2 to 99 %Switchable to external sensorMaterial bath/housing stainless steel, front and rear anodised aluminium
€1.311,00
Heating Bath HB Digital | Type: HB digital, Capacity of the bath litres: 4
Heating Bath HB Digital | Type: HB digital, Capacity of the bath litres: 4
Brand: IKA-Werke GmbH & Co.KGCompact and ergonomic heating safety bath for all tempering media.Ergonomic handlesKey button to lock heating bath temperatureClear, black-and-white displayPermanent set-point/actual temperature display3 different safety operating modesUSB interface
€1.699,00
Heating Bath HB eco | Type: HB eco, Capacity of the bath litres: 4
Heating Bath HB eco | Type: HB eco, Capacity of the bath litres: 4
Brand: IKA-Werke GmbH & Co.KGCompact and ergonomic heating safety bath.Ergonomic handlesClear, black-and-white displayAlternating set-point/actual temperature displayUSB interface
€1.362,00
Heating bath HBR 4 control | Type: HBR 4 control, Capacity of the bath litres: 4
Heating bath HBR 4 control | Type: HBR 4 control, Capacity of the bath litres: 4
Brand: IKA-Werke GmbH & Co.KGThe heating bath is noted for:Cylindrical bath shapeHeating elements integrated into the bath baseHeat transfer media can be low-viscous oil (50 mPas) or waterTwo carry handlesInfinitely variable safety temperature limiter according to DIN 12877Double-jacketed mantle protection against burnsDigital display for target, actual and safety temperatures as well as speedIntegrated magnetic stirrer drive to circulate the tempering fluid, allowing for better heat distribution in the bathRS 232 interface
€4.573,00
Heating bath liquid | Temp. range max. °C: -30 ... +90, Capacity l: 20
Heating bath liquid | Temp. range max. °C: -30 ... +90, Capacity l: 20
Brand: Heidolph InstrumentsAvailable in 3 variants
€971,00
Heating bath liquid, BUDDE | Container: 5 litres
Heating bath liquid, BUDDE | Container: 5 litres
Brand: Buddeberg GmbHUse:BUDDE heating bath liquid can be used continuously as a heating medium up to approx. 170 °C. Higher temperatures (below flash point) are possible, but will result in rapid darkening. The low pour point allows the bath liquid also to be used as a cooling medium. Mixtures with 10 % to 30 % water achieve best results.The crucial advantages of BUDDE heating bath liquid compared tothe oils or other organic liquid mainly used are:accidental spillage of water into the bath does not lead to dangerous spitting at temperatures over 100 °C, as the water dissolves in the heating bath liquid and subsequently evaporates safelyBUDDE heating bath liquid can easily be rinsed away with water which eases cleaning of laboratory equipment, e.g. distillation flasks, and also bench or floor if the bath liquid is accidentally spilled.BUDDE heating bath liquid does not foam when mixed with water.Viscosity on addition of water:BUDDE heating bath liquid is quite viscous at ambient or low temperatures, and therefore sometimes difficult to dispense. The addition of 10-20 % water reduces the viscosity and enables easier handling. If the mixture is then heated to 100 °C, the water evaporates without boiling. Further heating is only shortly delayed by this. Before next heating, water can be added again.Water solubility: BUDDE heating bath liquid can be mixed with water in any ratio. The hardness of the water has no effect on the bath liquid.
€189,00
Heating block set for digital dry bath LLG-uniBLOCKTHERM | Description: Heating block set, Dimensions (WxDxH): 95 x 150 x 60 mm
Heating block set for digital dry bath LLG-uniBLOCKTHERM | Description: Heating block set, Dimensions (WxDxH): 95 x 150 x 60 mm
Brand: LLG LabwareHeating block with aluminium beads as an alternative to exchangeable blocks with borings.The aluminium beads ensure high thermal conductivity. Various types of vessels, such as tubes, bottles, and microtitre plates can be individually assembled and simultaneously tempered in the dry bath. Easy to remove from the LLG-uniBLOCKTHERM thanks to two handles. The heating block holds a max. capacity of 700 ml.Scope of supply: Heating block, aluminium beads (1 kg)
€160,80
Heating blocks for digital dry bath LLG-uniBLOCKTHERM | Description: Heating block for 96/384 Microplate
Heating blocks for digital dry bath LLG-uniBLOCKTHERM | Description: Heating block for 96/384 Microplate
Brand: LLG LabwareAvailable in 9 variants
€114,70
Heating mantles Electrothermal® MHM-200 | Type: MHM-200, For flasks ml: 12000, Max. temperature: 450 °C
Heating mantles Electrothermal® MHM-200 | Type: MHM-200, For flasks ml: 12000, Max. temperature: 450 °C
Brand: Cole-Parmer Ltd. (Electro)Available in 4 variantsHeating mantle has a "V"-shaped design for large, pear-shaped and round-bottom flasks. The bottom opening allows 60° funnels of various diameters to be accommodated. Coiled heating element provides optimal heat transfer. Control heat throughout the mantle using three separate electrical circuits (top, middle, and bottom), each controlled with its own dial switch.Cool-to-the-touch design with powder-coated aluminium casingIndicator lamps for "power on" and "heat on" operationScope of supply: Heating mantle, three sets of integrated support rod clamps, power cords with UK and EU plugs
€4.113,04

Our website uses cookies.
Both we and our third-party partners use cookies. Some are strictly necessary for the site to function, but there are also optional cookies.

Necessary and functional cookies are always on. If you click "accept all cookies", you also accept the optional cookies. You can choose which cookies you want to enable via "set preferences".

Our website uses cookies.
What are cookies? What cookies do we use and why? Read more in our cookie policy

Necessary cookies

Cookies that are indispensable for your visit to the Website and the correct use thereof

Functional cookies

Cookies that make it easier and more pleasant for you to visit the Website, for example by personalising your browsing experience.

Performance cookies

Cookies that collect information about your use of the Website in order to improve the content of the Website and adapt it to the wishes of the User.

Third-party cookies

Cookies placed by third parties who offer their own services via the Website, such as social media, advertisements or video services.